Prg DMX Reference Guide 5.4 Manuel d'utilisateur Page 56

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 166
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 55
48 DMX512 REFERENCE GUIDE
Data Cables
Smart Repeater and DMX200 units are equipped with 5-pin XLR connectors for DATA IN and DATA THRU (out)
applications. DATA IN requires a 5-pin, female XLR connector and DATA THRU requires a 5-pin, male XLR connector.
When purchasing or constructing data cables, it is important that not only the correct cable type be used, but also
quality cable to ensure a reliable DMX512 system. Your cabling should meet the following USITT DMX512
specification requirements:
+ Suitable for use with EIA485 (RS485) operation at 250k baud.
+ Characteristic impedance 85-150 ohms, nominally 120 ohms.
+ Low capacitance.
+ Two twisted pairs.
+ Foil and braid shielded.
+ 24 AWG min. gauge for runs up to 1000 feet (300m).
+ 22 AWG min. gauge for runs up to 1640 feet (500m).
Note: Microphone type cables and other general purpose, two-core audio or signal cables are not suitable for use
with DMX512.
Refer to the USITT Recommended Practice for DMX512 guide for additional information regarding DMX512 systems.
How to obtain a copy is detailed in "Additional Documentation" on page 1.
The XLR 5-pin connectors should be wired as follows:
Pin/Wire Code to XLR Connectors
Data Thru
Cable Pinout
Male Conn
Pin 1
Foil &
Braided
Shield
Pin 2
1st
conductor
of 1st
twisted pair
Data (-)
Pin 3
2nd
conductor
of 1st
twisted pair
Data (+)
Pin 4
1st
conductor
of 2nd
twisted pair
Data (-)
Pin 5
2nd
conductor
of 2nd
twisted pair
Data (+)
Data In
Cable Pinout
Female Conn
1
2
3
4
5
1
2
3
4
5
Vue de la page 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 165 166

Commentaires sur ces manuels

Pas de commentaire